Switchable Magnetic Ground Clamp
- Available in two sizes
- MA-SMG-600 ->Up to 600 Amps
- MA-SMG-300 ->Up to 300 Amps
- Easy Connect & Easy Release Magnet with On/Off Knob
- Provides 5x the holding strength of regular magnets
- Will Not Collect Debris; Turn Off and Wipe Clean
- Provides an Outstanding Ground
- The Convenience of a Magnetic Ground...
Without the Hassle!
Easy to Mount
Simply attach your ground line to bolt on the copper boot.
To Use:
Surface preparations:
- As with all welding situations, surface prep is critical to a good ground. Ensure a “bare metal” area is cleared for attachment of the Magswitch Clamp. Failure to do so could result in an arc situation. (Note: An arc situation will void the warranty.)
- Magswitch Ground Clamp works only with ferrous metals.
To attach clamp:
- Determine type of boot for welding surface: pipe or flat boot. The boot is removed from the clamp by pulling out of the wire clip. Attach ground line to bolt on the copper boot.
- Ensure Magnet is in the “OFF” position (turn counter clockwise). Failure to do so could cause bodily injury.
- Ensure surface is bare steel – clear debris if present.
- Place clamp to surface. Turn Magnet Switch clockwise to “ON” position – full 180 degrees. (Note: the switch is easiest to turn when held against the metal ground surface.)
To remove clamp:
- Turn Magnet by rotating counter clockwise to “OFF” position – full 180°.
- Wipe debris from the clamp/boot surface.
For More Information, call
800-440-3967
US Patent Number 6,707,360
US Patent Applications
10/712,091, 10/487,538
| 
